My drawing has a hole table that calls out "T"
but the model has been modified to
I need the table to call out Ø0.145 thru Ø0.163±0.002 0.13 deep.
Try this.... An example with a modified C'Bore hole and also a Legacy hole. See attached SW2015 files.
<HOLE-SPOT><hw-cbdia> x <hw-cbdepth> Deep
Are you wanting to apply this format change to all tapped tapped counterbores? I believe the hole table reads the holecalloutformat.txt file, you could edit that.
I would recommend saving your changes as a new file and pointing your system to the new file (options > system options > file locations > hole callout format file) especially as you develop your modifications. If you want to modify some of these scenarios but not all, you could also create a new standard in this file that would callout the desired hole type with your chosen parameters.
Retrieving data ...