when I want to put a label to show a part into a system, I create a cutting plane but then when I put the label on the cut part it disappear !
Does somebody know how can I do ?
OK, one more thing you can check is your label properties. The properties I used for that label are below. If this still doesn't solve your problem I would suggest you attach your file here for us to look at. If for some reason you can't attach your file here you can always contact your VAR to see if they can dig a little deeper for you.
Have you tried to activate the label checkbox from the Collaboration/Annotations list?
The endpoint of the label has to be on the correct side. This means on that side which is NOT cutted!
Yes but if I want to show a part which is inside (I can only see this part thanks to the cutting plane !) ?
You want to show a label for a part inside the cutting area? And this part is cutted away?
But the label has to be shown?
is it possible to post a screenshot?
The label named "collimateur" desappear when I don't select it (but the chekbox on the left is activated) ! this part is cutted and the label has to be shown !
I hope it helps you to see my problem
Are you trying to do something like the screen shot below. If so just try and add the note after applying the cutting plane / planes. I can add my notes before or after cutting planes and rarely have an issue. This being said I have run into some before and was told it's a bug. You can just delete the cut and do it again as a work around. This was in 2014 though and since upgrading to 2016 I haven't had it happen yet,
Thanks for your answer ! I try to do the same thing like your screenshot but it doesn't work and I am on the 2016 version !
I found the problem was due to the type af attach used ! The type "model" I used desappear and the type "user" doesn't desappear !
Thank you for the answer !
Retrieving data ...