Can you please modify the .sldprt file as per attached picture??Deepak Gupta@
...Adm.. you should be able to do this..
1 - delete/remove the fillets. (or, offset the needed surfaces 0)
2 - offset the outer surface 5mm and 6mm
3 - extend where needed... reapply the fillets.
What issues you're facing in doing the same?
If it has all feature like extrude boss, revolve boss etc. then there was no problem. Because its just a part I cant modify it. Can you do that modification?
Thanks Paul, was about to post the same steps
Thanks Paul, can you please attach the .sldprt file?
Retrieving data ...