5 Replies Latest reply on Oct 4, 2016 6:10 PM by Robert Conklin

    how to save a drawing without saving the referenced document?

    Charles Robin

      Hi everyone

       

      I have a macro who open a lot of drawing to export them in PDF or DXF.

      I would like to add an action in the code : Change a propertie of the drawing.

       

      But to be efficient, it should save the drawing,

      If the referenced documents of the drawings are  bigs assemblies, i do not tell you about the time it take to save it each time.

       

      so, it is possible to save the drawing (just modify a propertie) without saving the referenced document?

       

      I know i can just put the referenced document on read-only mode,

      but can i

      directly open a drawing with all the referenced models on read-only mode,

      or should i first open all the referenced models on read-only mode, then open the drawing?

       

      Thank you

       

      Ce message a été modifié par : Charles Robin