Just a guess but, I think if you look at your view outline it will be covering the area that you see cut off.
It may have something to do with the Shaded with edges somehow covering anything under the outline area.
If you move your latch image up some will it show the logo and information below?
There may be a setting that will let it become transparent to anything under it but I have never seen this so I am not sure.
Hi Rick thank you for your reply !!
yes you right if I move it all up the issue is gone.
I have just Saved it As PDF via external PDF program . Clicked on the small printer icon and printed it into PDF external program and all was perfect.No issues.
This makes me think that Solidworks does not handle Saves as PDF well because I have not found any setting to correct this.
I might be very wrong if this can be corrected in settings......
There are some limitations or behaviors that people have seen with the Save As PDF. I use it all the time and don't see problems.
Try checking some of your "Options" settings (after you select Save As and then Adobe ...PDF, there is an "Options" button).
Check if any of these will solve your problem.
I have looked into those ,,Options,, but nothing would help. I do believe that the only solution will be to go with the External VIA PRINTER saving
unless SW will try to fix it.