hello guys, i have to make this part, but cant draw it

any help ty

Sinan, what kind of question is that? how long? how wide? how high? What is the diameter of the part, there is a clear arc in the part, What is the radius. You already have a model look at the feature tree to see how it was created.

Break it down into what you can do...

Sketch an arc and extrude a surface...

Sketch the "rectangular" shape and project it onto the arc surface as curves...

Sketch a circle that pierces the projected curves...

Sweep the circle using the curves as the path...

Nothing but a series of simple 2D sketches and simple features.

Sinan, I made a model. looks like yours, but I bet when I put them side by side they are a lot different.

Wow.. Doug went to town on helping!... there are at least 6 different ways I think we can show this.. and imho.. a simple analytical profile extrude (pie wedge) to the outside taper (surface boundary), add corner radii.. and sweep around the top edge.. with the 3mm profile.

...but... when looking at this geometry,.. the side profile tells me it was flexed.. so, I'm pretty sure it was a swept flat (pattern) and then a flex was applied.

Break it down into what you can do...

Sketch an arc and extrude a surface...

Sketch the "rectangular" shape and project it onto the arc surface as curves...

Sketch a circle that pierces the projected curves...

Sweep the circle using the curves as the path...

Nothing but a series of simple 2D sketches and simple features.