AnsweredAssumed Answered

Sheet metal lofted bend....

Question asked by greg eason on Oct 1, 2008
Latest reply on Oct 1, 2008 by greg eason
Ok I really need to make this as one piece but the sheet metal loft just limits me to two sides with no way to make a radius in between sketches.


Is there a way around this while still being able to flatten this as a sheet metal part.



if you look at sketch 3 on the shield trap part you will see where the radius is supposed to be.

and on the assy you see what the complete part is supposed to look like minus the that radius that I cannot seem to do.

Attachments

Outcomes