AnsweredAssumed Answered

My hole wizard configurations are lying to me!! Help!

Question asked by Sarah Dwight on Sep 15, 2016
Latest reply on Sep 15, 2016 by Richard Gergely

I was revising a model last saved in SW15, when I noticed some funny hole depths called out in the drawing.

I checked the model and sure enough, the tap drill depth shows differently in each configuration... when they should all be the same!

How is this even possible? Each configuration says that the other configurations match... but none of them do!

And I wasn't even editing this hole feature!

 

I had a similar problem recently with the Drill Angle changing of it's own volition, but that was on a custom hole size. (SPR 946030) I have to go back over my emails with IT support to figure out what I did to solve the problem. *sigh* Unless someone can help?

Outcomes