AnsweredAssumed Answered

Sheet Metal feature defaults to over ride

Question asked by Bill Schmid on Sep 12, 2016
Latest reply on Sep 12, 2016 by John Stoltzfus

I'm using SolidWorks 2013 to design fairly simple sheet metal parts.  Right or wrong, I usually design the part as an extrude and then "Convert to Sheet Metal."  This creates something like what's shown in the picture below.




The Sheet-Metal16 feature is always created with the box "Override default parameters" checked for both the bend radius and the K-factor.  Is there any way to make those boxes be un-checked by default?