This content has been marked as final. Show 2 replies
I don't know if this will solve you issue.
Start a new 3D sketch and select 3D sketch 1 and 3D sketch 2 and make Convert Entities, so will all be in the new 3D sketch.
Convert entities from 3D sketch1 & 2 is indead a good way to get a third 3D sketch,
but the problem is to get the intersection points of all curves in the third 3D sketch.
Maybe an other (better ??) solution is making a 2d sketch (outside the part) from 3d sketch 2, make the intersection point in these sketch, and project the sketch on the surface.
With an other 3D sketch now you can snap the intersection points on the surface from the projected curves.
3d-sketch-inters-points.jpg 126.8 KB