This is a revolved section. Inside diameter (7.900/7.898) disappears when I break the view. When I unbreak the view the dimension reappears. I get the same results with or without the broken out section.
Unbreak the view & look for the dimension. It might be in the broken out area. That's all I can think of
In my original post I stated......
" . . . When I unbreak the view the dimension reappears. I get the same results with or without the broken out section."
When you paced the dim, did you select the line where the break is at, if so reselect the dim and grab the end points and reattach them to the end of the line.
this is a shown, or model dimension, not a created dimension. I tried reattaching points of extension lines; get same result.
Insert the dimension from the model and use it, I am assuming you created this dimension in the drawing? Or am I wrong?
This is a model dimension, not a created dimension.
I've tried reattaching end points of extension lines; dimension still disappears when view is broken.
Retrieving data ...