2 Replies Latest reply on Sep 5, 2016 5:04 PM by J. Mather

    Trying to set up a sketch for a design study.

    David Godwin

      Hi guys,

      I am trying to set up a sketch for a design study. In the image attached you will see the construction lines around the solid lines.

      I am trying to make the sketch remain tanget to the construction lines as shown and then as I rotate the construction lines I need the sketch to move along the construction line changing the driven dimension ( in the middle of the picture). This needs to be done with the driving dimension of 0.02mm between the far side of the sketch and the construction lines.

      However, everytime I try to rotate the construction lines the whole thing distorts.

       

      I am very confused and would appreciate any help.

       

      Thank you.