AnsweredAssumed Answered

Problems with sheet metal angled corner flanges

Question asked by Chris Berry on Sep 2, 2016
Latest reply on Sep 7, 2016 by Jeffrey Farless

I'm having an issue with a sheet metal part that has angled corner. I cannot seem to get the angled flanges correct so that SW recognises them as true corner profiles. I've managed to do the angled corners but its not a nice solution & probably wouldnt give a nice profile for laser cutting. Because SW doesnt recognise these corners, I cannot add welded edges in these areas like I have on the rear corners.


Has anyone got a better solution on how to do these corner flanges?