10 Replies Latest reply on Oct 17, 2016 3:07 PM by Dwight Livingston

    Solidworks custom properties: Why cant these be pushed from drawing to part or assembly?

    Lawrence Kiefer

      Has anyone ever wondered why you can push custom properties from a part or assembly to a drawing? We transitioned from the drawing board, which for obvious reasons all of the data was put on the drawing. Then we progressed to Autocad where again, everything was put on the drawing, then enter Solidworks, where properties have to be put in on the part or assembly lever.

       

      Does anyone else think there should be an option to use the drawing as the primary input of all custom properties?

       

      I would love to hear community feedback on this.