0 Replies Latest reply on Aug 30, 2016 7:12 AM by Shaun Erasmus

    Curve Definition Error in Linear Dynamic (Harmonic) Study

    Shaun Erasmus

      Hi All,

       

      I have tried to setup a Linear Dynamic (Harmonic) Study using a frequency analysis. There are two options for that, generate a LD Study from the frequency analysis or to start a new LD study and copy across the material, contacts, fixtures and mesh - both yield the same results. Upon running the study I am giving the message "ERROR: Defined Curve(s) not proper" and I have no clue what this means in this case.

       

      I was unable to find anything on the knowledge base related to this error. Any assistance would be greatly appreciated!