3 Replies Latest reply on Aug 18, 2016 9:59 AM by Glenn Schroeder

    HoleWizard Hole Type graphic

    Jason Wallace
    Jason Wallace Aug 18, 2016 8:50 AM

      Hello Solidworks Team,

       

      I just want to point out that the "slot" graphic (bottom right in below image) is awfully confusing for newbies like me. It looks so much like a through-hole that I spent several minutes trying to figure out why I was forced to set a slot length (which defaulted to 0 and created an error, by the way.)

       

      Has anyone else new also had this problem?

       

      Just FYI for future UI updates,

      Thanks,

      Jason