4 Replies Latest reply on Aug 17, 2016 5:34 AM by Mark Greenwell

    Show bolts in a BOM

    Mark Greenwell



      I'm stuck again. I've added some Smart Fasteners (Counter sunk bolts) to an assembly.


      For the 2 plates used the information in the BOM shows ok but how do you get the bolts added in this assembly to also show up in the BOM.

      The qty does show up. but not size or length.


      Normally I would not need to show this, but on this occasion we have to drill and tap one plate, the other plate has just a straight counter sunk holes.


      These then need to be bolted together and then drilled and tapped through both plates at other positions.


      I cant seem to get the counter sunk bolts info (16 wtd) to show in the BOM





      Mark (SolidWorks 2016 sp4)