I am trying to Flatten the part and getting error - "This part intersect itself after bend operation". I can not figure out where is the problem and how to fix.
Dave,,, I don't get that error with SW2015 2.1 (no matter what settings I use) The part does, however, intersect itself. Try editing the sketch for Edge-Flange2 to trim the corner and see what happens.
Thank you Dennis, Trim the corner , fixed the problem.
Dennis, I have another issue on same model, I am not able to set "Miter Flange" Flange position as
- Material Outside
Or - Bend Outside.
If I select any of these options -Miter Flange fails. Can you take a look and let me know what I am doing wrong.
According to the lesson I'm assuming you are doing, you do have the correct dim of 51.5mm on your model for Miter Flange1. I suppose you are talking about a miter flange later on in the lesson. I would bet that you have the sketch line attached to the wrong side of the material. Just a hunch.
I do not see any problem other than what Dennis Bacon point it but still it flatten
Retrieving data ...