I'm trying to make a stent and am trying to wrap emboss my flat sketch but when I do, it says the feature failed to cut. I'm puzzled as to why. Hopefully my file has been attached.
Is this what you want
If either of the what you want i will say that the way set up your sketch is not good you put so much relationship that will slow your machine
2. use wrapped and cut
3.use linear pattern
4. use combine
5. This is how i did
I wont send you the file since you using 2015 student and also for you to learn
Wow thanks so much! The wrap worked this way and I was able to finish the stent.
Good to know that it works! ill give you some advice, do not put everything on the sketch that will make the sketch so complicated it will slow down your machine, will take time to rebuild your feature, it will give you ease of troubleshooting and it is easy to modify when it is needed.
Retrieving data ...