AnsweredAssumed Answered

sheet metal cone problem...

Question asked by Jim Hilgenberg on Sep 22, 2008
Latest reply on Sep 22, 2008 by Jim Hilgenberg
I have pulled all my hair out over this one...so frustrating. See attached SW08 file. If the values at either end of the sketch are changed, say small end 2.000 to 4.000, the sheet metal fails. Or if you change the large end from 6.000 to 4.000, it fails.

I just don't get it! What's going on here? Am I missing something? I still have angled cuts to make on both ends but can't even get past this seemly simple point.

Any help is greatly appreciated...thanks.

Jim

Attachments

Outcomes