Don't know about others but setting precision in cutlist tables is still driving me nuts!
I have set all precision options that I'm aware of, to 1 decimal place in drawing, model,mass props and even on in profile file (sldlfp) and I still get this flakey bit of software rounding to 0 decimal places in drawing table. As can be seen the 1 place precision shows up in model cutlist but the table in drawing seems to be controlled by a quantum force somewhere else in the universe.
Anyone shed any wisdom - I've looked in all the obvious places, any hidden nooks and crannys that I'm not looking in?
I SHOULD NOT BE THIS HARD OR UN-OBVIOUS !! TO CHANGE ...............!!