I've done 3 assemblies already this morning, nearly identical to this one, and have had no problems at all. Suddenly with this assembly, the cable refuses to follow the routing line.
What am I missing?
What do your wire route parameters look like? (Route wires property manager) I know if the second value is too large or too small this can sometimes happen.
Scratch that - I see now. Splines are not supported geometry for the route path. Line segments only.
Strange that it worked several times before, then...I'm not sure I am convinced that splines won't work...
Did I just get lucky several times, and suddenly SW is deciding it doesn't like splines now?
Edit - and to your previous question, I tried a dozen or so different settings, my "distance between routing paths" is always always always "0.01mm". I don't want wires jumping off of a preferred path just because some other lines pass nearby but had some issues using zero - not sure if 0.01 fixed it but it has been working so I haven't touched it.
I tried the following values for the "point to line" distance:
1, 10, 15, 17, 20, 25, 25.4, 50, 75, 100, 10000, 100000.
Oh, is this just using SOLIDWORKS Routing or SOLIDWORKS Electrical 3D? Perhaps I misunderstood
This is SolidWorks Electrical 3D (2015).
Not sure what was wrong with this project, but as mentioned I had done a few before by the same method and everything worked fine. I have also since done another 4 or 5 by this same method, and all have worked fine. Just this one project won't route. So instead I just manually added a half dozen spline points, dragged and snapped to my routing line, updated lengths and got on with my life.
No idea what was wrong, or what I did differently in this case that caused this issue.
Retrieving data ...