Eric Wild

Rolling Sheet w/ a Hem

Discussion created by Eric Wild on Sep 19, 2008
Latest reply on Sep 20, 2008 by Philippe Keirse
I am attempting to model a sheet metal part with SolidWorks 2008 that includes a one inch hem on one end and then is rolled to form a cylinder. I've been able to deal with rolling the sheet by treating it as a large radius hem, but I am then unable to add the one inch hem to the end of the cylinder. I've attempted starting with both the "roll" hem and then the 1" edge hem and vise versa. I've attached the model and would appreciate any guidance anyone might have.

Attachments

Outcomes