4 Replies Latest reply on Sep 29, 2016 2:26 PM by Siavash Khajehhasani

    VeroWhite (3D print) material simulation

    Bob Emac

      Hi all,

       

      I would like to optimize a part which is due to be produced via 3D printing. The material which will be used is the VeroWhite from StrataSys (and does not exist in SW simulation 2015). The datasheet they provide does not allow to create a material from scratch in SW simulation.

       

      Do you know a plastic material which is close enough to the VeroWhite so I could use it instead?

       

      Kind regards,

       

      Bob.