AnsweredAssumed Answered

Surface loft not using all guide curves

Question asked by Haridas Attur on Aug 2, 2016
Latest reply on Aug 18, 2016 by Haridas Attur

Hello all,

 

I am trying to use the surface loft command and I have been having some issues. Below is the sketch of the part I am trying to create. The two sketches at the either ends are the profiles. The three squiggly/snaky lines and the four straight lines are the guide curves.

 

After I use the surface loft command here is what I get:

The two ends are OK but the center is not squiggly/snaky. For some reason the surface loft is is not using the center squiggly guide curve but is using the rest of the guide curves. Not sure why it is doing this. Attached is the model/part.

 

Any help appreciated.

 

Thanks, harry.

Attachments

Outcomes