I am importing a dxf file to use in a linear sketch pattern to create a perforated piece of wood but there are too many lines and SW quits responding. Any ideas?
not 100% sure if this is what you mean-
but it is imported, just create a block,
extrude cut or whatever
and pattern as required
hope this helps
have a good'n kelef
I seem to have gotten it with the unexploded block. So good there, I am however curious why you have the axis as well as it set up as a 3d drawing? I am still getting back into SW after some years off and all little hints help.
just how that template is setup-
I didn't fully understand from your original post
where you wanted your sketch so just
imported and plonked it on a plane
the axis doesn't mean nauwght in that case
glad you got it done the way you wanted
Probably the issue comes because the profile is a block.
Explode the block and then try to import it again.
I found that not exploding the block as either a dwg or dxf seems to work. But exploding them is causing issues.
Retrieving data ...