In my assembly file BOM table is showing different value in total
and in mass properties window it is showing different value can anybody have a solution
It would be hard to suggest anything without looking at the files. Can you make a dummy assembly and upload to check?
but what i say is create 4 or 5 parts and assemble and apply material then u can check the difference it is 2015 version
Just checked and both are same for me. Can you make a dummy assembly file with few parts showing the issue?
Are some of your parts using pounds instead of kilograms? If so, SolidWorks 2015 (do not know about SW2016) does not convert the values to kilograms when they are inserted into a BOM (it does convert units in mass properties). So this may be the reason for the difference. If this the case then you have two options, change the parts using pounds to kilograms or write an equation to convert pounds to kilograms and substitute that value in the custom properties (we had to do this in a part that some configurations needed to be displayed in pounds and others in kilograms.
Retrieving data ...