how do i cut my rods so that it is tapered(slanted) and how do i assemble them to a top piece with it being tilted at a certain angle?
How do i position the already tapred rod at a certain angle?How can i make this strait cut rod tapered?
When drawing the rods draw in the right plane, draw a construction line from the point of origin up to the length of the rod, then the top line is connected to the construction line and is in a horizontal position and do the same at the bottom of the construction line then draw a line from the short line to the long line and select the construction line again use the Revolve Feature to complete the part. You will be able to mate the pin to the plate with a concentric mate....
Create an extruded cut feature on the ends of the rod.
THANK YOU !
Retrieving data ...