1-D8GBKO

Plug in location

Discussion created by 1-D8GBKO on Sep 10, 2008
Latest reply on Sep 10, 2008 by John Burrill
  • Comment • 1
Where does Solidworks pull Plug In data from? When installing a plug in application, solidworks picks up what was loaded. Where does this data reside. I'm attempting to get Solidworks to use the Smarteam plug in on a 64 bit OS, but need to make a change to the plug in itself. I need to know where this plug in data is stored.

For instance, if I install CosmoWorks, Smarteam then recognizes it as a plug in. Where is this held?

Outcomes