AnsweredAssumed Answered

3D Duct Offset

Question asked by Jeremy Hall on Jul 27, 2016
Latest reply on Jul 29, 2016 by Alin Vargatu


I'm trying to draw a 3D duct offset, as the title suggests.  I have the 3D sketch, (see attached), and after much time and research, still can't get it to extrude/fill/actualize into the 16GA duct I need. 

Also, is there a way to transform this sketch directly into a "hollow duct", with the small ends open, or must I totally fill it and then transform using sheet metal?

Please advise.


Thank you for your time!