I am using a trial of Simulation. I have build a small model to test some ideas and learn simulation. The model is a shaft with an offcenter, eccentric on the end that when rotated will slide a clamp head in linear motion. The model moves as expected when I am modeling mode. When I run simulation it runs like the shaft is bonded to the block. It seems like no force is translated to the clamp head???
What am I doing wrong?
Eric,Not sure what's going on, but when I download and try to open your files it causes SolidWorks to crash. I can open any file but yours, and when I do the program completely freezes and then force shuts down.
Not sure if anyone else is having this problem, but I only mentioned it to see if someone else could try to download it. Perhaps it is just my machine?