AnsweredAssumed Answered

Sketches in Flat Pattern, using Export to Flat Pattern

Question asked by Larry Gray on Aug 11, 2008
Latest reply on Aug 12, 2008 by Larry Gray
Hello,
I've seen several posts about laser etching, relief cuts, and knockouts, and the recommendation was to use a map file. I'm probably missing something, but I cannot get sketches to show up in the DWG file. I've created a layer called Etch, and selected Geometry, didn't work. I also tried Sketch Lines, which didn't work.
Basically we need just lines and arcs to show in the flat pattern, how can I do this?

Thanks,
Larry

Outcomes