AnsweredAssumed Answered

All wires are routing 1mm diameter and gray/white...

Question asked by Caleb Youker on Jul 19, 2016
Latest reply on Jul 27, 2016 by Tim Pulaski

So, when I route some items in my assembly, the wires come out fine, but for certain components I seem to be getting a lot of this:

 

See image above.

 

These wires are all 1mm and gray, but none of the wires in my project are 1mm and gray.  There's a couple gray wires used in this project but none of them are shown here, and every last one of the wires used in this project is defined as 2.4mm diameter.

 

No errors are shown after routing.

 

 

It's as if SWE is ignoring the wire properties and is completely unaware that it is doing so.

 

Any ideas out there as to what might be wrong here?  What could be causing this to happen?

Outcomes