AnsweredAssumed Answered

can not display bend line

Question asked by Peter Dorn on Aug 8, 2008
Latest reply on Sep 3, 2008 by Jerry Steiger
Does anyone know what this error really is?

I created a c channel part in shetmetal. This part was made as a flat plate first. then added to flanges. I used the profile of the 2 flages and the initial flat plate to elongate the part.
I still have a c channel part. Very basic.
The part flattens fine prior to the extrude command to elongate the part. After the extrude command, the part errors on unsuppressing the flat pattern. I get one of the flages to flatten but the other will not.
The error I get is "can not display bend line"

Any clues?

Outcomes