2 Replies Latest reply on Aug 8, 2008 8:05 PM by Philippe Keirse

copy block from DWGeditor to SW sketch don't work in SP4.0

Philippe Keirse Aug 8, 2008 3:42 PM

I always used blocks, maked in DWGeditor and copy - paste it in a SW sketch as a block.
I upgrade SW from SP3.1 to 4.0.
Now, if I do the same, the block is gone and I have only blue sketch lines in SW.
I upgrade also DWGeditor but the problem keeps the same.

Can anybody tell me what's wrong here?

Thx

copy block from DWGeditor to SW sketch don't work in SP4.0

Tony Cantrell Aug 8, 2008 7:05 PM (in response to Philippe Keirse)

I havnt used copy blocks, but if you explode the block then copy, it works fine. You can make it block after its in SW.
Like Show 0 Likes(0)

Actions
- copy block from DWGeditor to SW sketch don't work in SP4.0
  
  Philippe Keirse Aug 8, 2008 8:05 PM (in response to Tony Cantrell)
  
  Tony,
  
  I want to keep the blocks from DWGeditor in SW sketch.
  In SW2008 it was never a problem, copy - paste a block in a sketch keeps always a block.
  Now with SP4.0, if you paste the block in the sketch it automaticly becomes sketch lines.
  From these sketch lines, yes you can make a new block, but that's extra work.
  
  Greetz.
  
  Like Show 0 Likes(0)
  
  Actions

Go to original post