AnsweredAssumed Answered

When I attempt to open a .stp file, receive the following warning: "The file being read in is not a step ap203 or ap214".

Question asked by Michael Brodnik on Jul 15, 2016
Latest reply on Jul 19, 2016 by Michael Brodnik

When I attempt to open a .stp file, receive the following warning: "The file being read in is not a step ap203 or ap214".

 

I can open the file as a single part, however, the piece was created as an assembly. When i go through the options of opening the .stp file as an assembly the assembly that opens is just a blank file. Is there anything I can do besides asking the customer for a different file type?

 

Thank you for the assistance!

Outcomes