-
Re: Can flow simulation display out a min and max temperature point on a contour plot similar to ANSYS?
When you look at the colormap in the legend of the plot, there are two ways to automatically set your boundaries. One of them is for global min/max values, and the other one is for plot min/max values. Holding the mouse cursor over the buttons will bring up a tooltip to explain which button is which.
-
Re: Can flow simulation display out a min and max temperature point on a contour plot similar to ANSYS?
Thank you Amit,
Once the plot min/max settings are chosen...is there a way to physically see where on the geometry the min and max locations reside?
-
Re: Can flow simulation display out a min and max temperature point on a contour plot similar to ANSYS?
Not directly, but you could use the isosurface tool to try to isolate your high values and find them that way.
-
Re: Can flow simulation display out a min and max temperature point on a contour plot similar to ANSYS?
That is what I thought. That technique is ok but it would better to have the ability to put a marker on the min and max values. Solidworks....this would be a great enchancement.... (hint hint)
-
Re: Can flow simulation display out a min and max temperature point on a contour plot similar to ANSYS?
If you post an enhancement request and link it here I'll support it. There's a way to do it somewhere on the forums, not sure exactly how.
-
Re: Can flow simulation display out a min and max temperature point on a contour plot similar to ANSYS?
I'm not sure either. I would think they read the forums.
-
Re: Can flow simulation display out a min and max temperature point on a contour plot similar to ANSYS?
It's very rare to see any official DDS rep in this particular sub-forum, I wouldn't hold my breath. You could also try to get a ER pushed through your vendor.
-
-
-
-
-
-