3 Replies Latest reply on Jul 13, 2016 5:45 AM by Steve Crompton

Mag lines

Steve Crompton Jul 12, 2016 10:14 AM

Is there anyway to have 2 views sharing one mag line to bring my balloons in line?

I have an iso view and a reverse iso view of the same item. I have to have both view to show detail on both sides. These views obviously share the same BOM.

Its no biggie if its not possible but would be nice. I'm currently hanging on to 2105 until SP4 is out til I jump ship to 2016 in case that matters.

Thanks

Steve

Re: Mag lines

Deepak Gupta Jul 13, 2016 12:17 AM (in response to Steve Crompton)

No you can not have MG common for multiple views. You may raise an ER for this.
Like Show 0 Likes(0)

Actions
- Re: Mag lines
  
  Steve Crompton Jul 13, 2016 4:34 AM (in response to Deepak Gupta)
  
  Thanks Depak. I will raise an ER.
  
  Steve
  
  Like Show 0 Likes(0)
  
  Actions
  - Re: Mag lines
    
    Steve Crompton Jul 13, 2016 5:45 AM (in response to Steve Crompton)
    
    If anyone else is interested in this as an enhancement then its:-
    
    ER - 1-11562411136
    
    Thanks
    
    Steve
    
    Like Show 0 Likes(0)
    
    Actions

Go to original post