I have done a simulation of Wiper Mechanism
In RH Side you will see the link joint rotate 36 degree while it should be in straight condition
I have mate them thru axis point to axis point
Kindly guide me
Thanks in advance
It is kind of hard to see what's causing this behaviour without actually looking on the model setup. Maybe you can replace the mate mentioned with a hinge mate. Are you able to upload the model to the forum?
If I am looking at the right area (see below) the link is free to rotate about it's long axis because both ends are mated point to point. In the real mechanism there would usually be some physical limitation to this rotation. While it is important that you make sure no binding condition can be created, I have gotten around this in the past by creating a reference point in the driving to which I mate a plane that exists in the link. The plane to point mate allows the link to move around without being unnecessarily bound up by the additional mate.
If you include your model as Sindre asked we could propose more definite solutions.
Retrieving data ...