AnsweredAssumed Answered

SW-Part Number for Configurations

Question asked by Andrew Holowack on Jul 8, 2016

I know there used to be an issue with modifying the "SW-Part Number" in earlier version so I was wondering if this has been addressed over the last few years. Specifically I want to specify a configuration specific property for PartNumber and have this part number be used for the BOM Part Number and show up in next to the configuration name e.g. "TestPart [ PartNumber ]". I know this can be done using a design table with the heading $PARTNUMBER but I would like to be able to push this into files using PDM whether there is a design table or not. Is this possible?