AnsweredAssumed Answered

Electrical Routing Problems

Question asked by 1-CDBR7G on Aug 5, 2008
Latest reply on Aug 6, 2008 by 1-CDBR7G
Sometimes I get in to a situation where the stub on my connector has been deleted (like when I mate the connector after I place it - I don't always build in the smart mates). When this happens, the Edit Wires dialog doesn't recognize a valid path to the connector. What is the trigger which clues the software into knowing that the route can "get" to the connector? I've tried making route segments coincident with the connection point, and co-linear with the connection point axis, but the only work-around that I've found is to delete the connector and insert it again.

Mike Barber
2009 x64

Outcomes