I have a problem files (.SLDASM) and (.SLDPRT) does not open gives me a message as follows: An error occurred while opening your file, contact Support to try to find a solution
Do you have free space on the drive where you are opening (double the size of the files)?
Can you attach the files here?
voila I capture an image to make you see the problem, I use the logiciele much as french Version
Rather than a mere pretty picture - can you attach an actual *.sldprt file here that exhibits the behavior?
I can not send me the link because there is no option to transfer files there just to transfer the simages you can give me your email to send you the file plz
thank you very much here are the three files now three extensions solidworks who will not open I have a version of solidworks 2013
The problem could be that the files were last saved in SW2016. SW2013 will not be able to open them.
waths a solution of this problem this ??
You need to get these files converted to Parasolid/IGES/STEP etc. and then you can open them in lower version. No other way out. Also note that all history would be gone.
Have you tried to... idk... contact Support to try to find a solution?
Most likely broken files due to software crash during save opperation. Your VAR may be or may be not able to fix them.
You can look at these locations for a backup:
If files are 1 or 0 bytes size, they are beyond repair.
Retrieving data ...