AnsweredAssumed Answered

Bending existing component (Solidworks)

Question asked by Anthony T. on Jun 27, 2016
Latest reply on Jun 27, 2016 by Mike Pogue


I'm trying to bend an object coming out of one surface on front plane and going down to a bottom surface on top plane with 90 degrees angle.

Please see the attached picture.

You can see that I have simply drawn two extrusions: one from the object on top plane and the other from the object on front plane. Then they collide and make it look like it is one part, which of course it isn't.

Ideally I would want it to be an arc going from the object on top plane to the object on front plane, but I can't make it happen.

Please help.


Best Regards,