I'm new to Solidworks and trying to design channels. I am not sure how to remove the surfaces where my channels intersect. I have tried all sorts of options but not able to. Can someone please point me in the right direction?
I'm a bit confused at what you are trying to do Akhila... It looks as though everything has worked as you intended. I simply changed the transparency and deleted the extra bodies. Let me know if this is not what you intended.
Thanks for taking the time to look at my question and sorry if I was not clear. I have attached an image highlighting what I mean by getting rid of the intersections. I need all the channels to act as one piece as I would need fluid to flow through them.
Yes, that's right Jason. Could you please tell me what steps you followed to make this happen?
There're many ways to do this. Mine is 1-2-3
1- Sketch 2 "corner rectangle" on the bottom surface
2- Extruded to top surface and Merger result
Retrieving data ...