Hi All,

Can someone explain how to properly setup and use a k-factor based bend table. I have tried it today and it doesn't seem to give exactly the result I was expecting.

I am primarily processing stainless steel, 304 and 316, with a range of thickness from 1.5mm up to 6.0mm.

If possible could someone share a copy of their gauge tables and k-factor bend tables for reference purposes to see how they are set up. I looked at the helpfile from SW and the information is pretty sparse.

Thanks in advance,

Declan.

Can someone explain how to properly setup and use a k-factor based bend table. I have tried it today and it doesn't seem to give exactly the result I was expecting.

I am primarily processing stainless steel, 304 and 316, with a range of thickness from 1.5mm up to 6.0mm.

If possible could someone share a copy of their gauge tables and k-factor bend tables for reference purposes to see how they are set up. I looked at the helpfile from SW and the information is pretty sparse.

Thanks in advance,

Declan.

Thanks,

Declan.