1-FPIXCI

Adding sketched bends...

Discussion created by 1-FPIXCI on Jul 5, 2008
Latest reply on Jul 7, 2008 by Michael Duncan
I put this in the parts section but it should probably be here instead... can someone help add these bend lines and fold the part up..

Can someone help add these two bend lines, I cannot do it for some reason... it keeps telling me that i'm bending over other bend lines.

Additionally can someone tell how to take an initial drawing such as a dxf make the internal bend lines for construction only in order to create a base flange and then after the flange is created to change those lines from construction lines to sketched bend lines.. thanks...

Outcomes