AnsweredAssumed Answered

How to close complex corners

Question asked by Kevin Bouwman on Jul 5, 2008
Latest reply on Jul 8, 2008 by Kevin Bouwman
How do I close the corners on the tool chest body I am designing? Do I need to take a wholy different approach? I tried shelling a solid and riping the corners but I couldn't get that to work either. With the bends in the front panel, rear panel, and the side panels all different but needing to match up in a mitered corner I am at a loss as to how to get the result I need.

I would also like any suggestions on how to design this so the ends of the chest are actually separate parts that get welded on later because that is how I will have to fabricate it.

Thanks,
Kevin

Attachments

Outcomes