This surface which needs to be thicken by 2mm is not getting thicken,I am getting the error which is "Unable to thicken the surface".
There is a complex corner on your surface that's causing this error. This is caused by bad selection when the boundary surface were created. This is how you should make the selection in order to thicken the surface:
Hope this helps
Big Thanks to you,your help is highly appreciable.This solves many of the problems.Now the thing is that if we want to merge the result then what should I do.
3D Designer/Robotics Engineer
Hi, good to hear!
So the next step is to get it into one solid body. This is not possible because of some areas with "zero thickness geometry". To do this we need to make a few modifications. First I extended the base geometry and trim it with a copied surface from the boudary face that we made before. Then I trimmed the bottom face since the thickend command made it go through the bottom face.
Once this is done, I cut the model in half, combine it and mirror.
I attached the model so you can see the steps.
Thanks a lot from your side.God bless you.
Retrieving data ...