4 Replies Latest reply on Jun 16, 2016 1:00 PM by MATT AUSTIN

    DogBone Sketch

    MATT AUSTIN

      Hello All,

      We use a Plasma Laser to cut many shapes from Steel Sheet. The Laser cannot deal with sharp corners and in most cases we want to put parts together like jigsaw puzzles, so we are forced into making relief cuts with many radii. We start with a rectangle then add tangent curves (selecting each and setting them equal to each other) to make the reliefs, then either mirror or redo at each corner, finally we trim out the old corners of the rectangle.

      Does anyone know an easy way to do this? Maybe a macro?