Can you overlap the different configurations in the drawing?
Easy enough to do that - I would create a new assembly and insert pre-cut assemblies or parts, this cut needs to be the same for each item, can be in different areas, but you need the sketch the same for mating in the final assembly/configuration..
Are you working with individual parts or assemblies??
One way I could think of (not sure if it is the most efficient?) is to drag the full views of each configuration onto the drawing screen, but have them off the edge of the paper. Then sketch whatever form you desire (whether it be a straight line, spline, broken line...) onto each of these configurations. Make this sketch an enclosed area, and with the sketch highlighted, select a detail view. Drag that detail view into position from there.
I'll try to get a really simple picture posted in a few minutes to help.